Phazer Soft Shell Backpack

Dramatically decrease chemical, packaging, labor and waste with the innovative Phazer™ Mobile Floor Care System. With this system the operator carries floor finish in a self-contained carrier and uses an ergonomic flat mop to apply finish.

Features & Benefits:

• Ergonomic design eliminates bending, reaching and wringing out string mops.
• Ergonomic applicator mop design minimizes awkward stance.
• Completely contained system minimizes operator contact with chemicals
• Flexible, collapsible pouches create 83% less plastic waste than 5-gal pail system.
• Innovative valve design ensures excess product in feed line runs back into product bag for later use, minimizing product waste up to 20% over traditional mop and bucket.
• Fluid, uninterrupted motion eliminates the disruption of rewetting a string mop, enabling workers to increase productivity up to 73% over mop and bucket system.

Directions for Use:

Loading the Product Bag:

• Open pack cover by releasing the plastic buckle on the locking strap. Note the orientation of the product bag and the bag spout.
• Place the product bag into position and slide the inside slot of the bag collar into the slot on the pack.
• Push the collar completely down and snap into place as shown. This will help hold the collar at its most downward point during use to insure complete product evacuation.
• Remove the shipping dust cap to gain access to the self sealing bag insert.
• Attach the delivery tube connector as shown by threading onto the bag spout.
• Turn until it is completely engaged.
• Rotate the pack cover closed and secure the locking strap.

Connecting the Applicator Handle to the Applicator Head:

• Insert the stationary pin on the connector clip into one of the center holes on the applicator head.
• Slide the bolt of the moveable pin back and rotate the connector into position. Release the sliding bolt to secure the connector to the applicator head.

Preparing the Applicator Pad:

• It is always best to pre-moisten the applicator pad. This will help to saturate the pad with finish during initial use.
• If you are using a new pad, rinse it thoroughly several times.
• Ring out the excess water so the pad is left damp. Always inspect the pad to ensure that all fibers and lint have been removed, especially if it is a new pad.
• Center the damp pad onto the applicator head. Press firmly into place.

Additional Notes:

• For application techniques, proper use and additional directions for use, refer to the Phazer Installation and Operation Manual and the specific product(s) I&O Manual

Lead times for this product may vary - direct ship from manufacturer